Brodit 511357 Fiche technique télécharger pdf (Page 2)

1. 2.

INSTALLATION INSTRUCTIONS

4.3.

Please read all of the instructions and look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed

screws.

3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the

screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time

tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a bit so

the holder is firmly in place, but still can be adjusted.

4. The holder is in place.

2(2)

1 2

Pas de commentaire

Brodit 511357 Fiche technique Page 2